Remove Communication Cable; Power On, Power Off, Sleep, Reboot - Newland NLS-HR1050-7 Series User Manual

Remove Communication Cable

Get an appropriate needle or a straightened paper clip and then follow the steps below:
1. Disconnect the power adapter from mains and the scanner if there is one.
2. Insert the needle into the disassemble hole (Fig. 1-6).
3. Pull out the cable slowly from the scanner while pressing the needle in. Then remove the needle.
4. Disconnect the cable from the Host.

Power on, Power off, Sleep, Reboot

Power on the scanner
Connect the scanner to a host device. Then the scanner will be turned on and automatically go into sleep
mode.
Power off the scanner
There are three ways to turn off the scanner:

Remove the cable from the scanner.

Remove the cable from the host device.

Disconnect the power adapter from mains or the scanner.
Enter the sleep mode
If no operation is performed on the scanner for some time, the scanner will automatically enter the sleep
state.
Reboot the scanner
If the scanner stops responding to input or runs abnormally, disconnect the scanner from the host device
and then reconnect it.
7
Fig. 1-6