Set Terminating Character Suffix - Newland NLS-HR1050-7 Series User Manual

Set Terminating Character Suffix

The scanner provides a shortcut for setting the terminating character suffix to 0x0D (CR) or 0x0D,0x0A
(CRLF) or 0x09 (Horizontal Tab) by scanning the following barcode.
Terminating Character 0x0D
Terminating Character 0x09
To set other terminating character suffix, scan the Set Terminating Character Suffix barcode, the
numeric barcodes corresponding to the hexadecimal value of a desired terminating character, and the
Save barcode.
Note: A terminating character suffix cannot exceed 5 characters.
Example: Set the terminating character suffix to 0x0A
1. Scan the Enter Setup barcode.
2. Scan the Set Terminating Character Suffix barcode.
Scan the numeric barcodes "0" and "A". (See the Digit Barcodes section in Appendix)
3.
4. Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5. Scan the Enable Terminating Character Suffix barcode.
6. Scan the Exit Setup barcode.
91
** Terminating Character 0x0D,0x0A
Set Terminating Character Suffix
** Enter Setup
Exit Setup