Scanning Instructions - Newland NLS-HR1050-7 Series User Manual

Scanning Instructions

When the HR1050 scanner is in the Manual mode, you can follow the steps below to scan a barcode:
1. Hold down the trigger. Then the scanner will project a red aiming beam.
2. Aim the red beam across the center of barcode, as shown in Fig.1-10.
3. Release the trigger when the red beam goes off. For a successful read, the scanner will beep and
send the decoded data to the Host.
Note: For barcodes of the same batch, the scanner keeps a very high success ratio in certain distance
which is regarded as the optimal scanning distance.
Fig. 1-10
10