Removing The Rack Mount Ears From The Ssa Switch; Installing The Adapter Plates - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

Table 23: Contents of SSA-FB-MOUNTKIT (continued)
Item
10-32 pan head screws (black)
10-32 cage nuts
Note
The SSA-FB-MOUNTKIT mounting kit does not include rack screws. You must provide screws
or fasteners appropriate to your rack for securing the rails and the SSA chassis in the
equipment rack. Each procedure in this guide specifies the number of rack screws that you
must provide.

Removing the Rack Mount Ears from the SSA Switch

Remove the rack mount ears from both sides of the SSA switch before continuing with the mounting kit
installation. See Figure
Figure 22: Removing the Rack Mount Ears
1 = Rack mount ear
The removed rack mount ears and screws are not used in any mounting kit installation procedures.

Installing the Adapter Plates

Two adapter plates come with the mounting kit. Adapter plates are used to secure the chassis to:
•
The rail and extension assemblies used in the four-post rack configuration (see
Mount Installation
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
22.
2 = Rack mount ear screws
on page 56).
Optional Rack Mount Rail Kit Installation
Quantity
2
2
Four-Post Rack
54