Attaching To A Tractor - Landoll Brillion LSP5 Operator's Manual

Attaching to a Tractor

When hooking up seeders:
• Attach tractor.
• Remove Klik Pin, pull parking pin into outer position,
• Replace Klik Pin.
When unhooking seeder:
• Remove Klik Pin, push in parking pin,
• Replace Klik Pin.
• Disconnect tractor.
Klik Pin
Parking
Pin
3-2
TABLE OF CONTENTS
Use this hole when
Connected to tractor
Use this hole when
Disconnected from the tractor
Parking Pin
(each side)
Quick
Attach
Frame
Figure 3-2: Attaching to a Tractor
On LSS6, skid steer models, there is a parking pin located
on each side of the frame. In addition, a quick attach
frame attaches to the rear frame tube of the seeder by
means of two pins and Klik Pins. See Figure 3-2.
Pin,
(2) Klik Pins
7K458-0221