Landoll Brillion LSP5 Operator's Manual page 28

Fasteners
Before operating your Brillion machine, check all
hardware for tightness. Use the Tightening Torque Table
as a guide. See Page 4-1.
After a few hours of use, check entire machine and tighten
any loose nuts or bolts. Daily or periodic checks should be
made thereafter.
When replacing bolts, be sure to use fasteners of equal
grade.
• Values are given in foot-pounds.
• Use GRADE B lock nuts with GRADE 2 and GRADE 5
bolts only.
• Use GRADE C lock nuts with GRADE 8 bolts only.
Acre Meter
The battery operated acre counter uses 3 AA batteries.
The batteries should last between 5 and 10 years. The
acre counter will last much longer than that. Eventually,
you will have to replace the batteries. The acre counter
will display "LObAt" when the batteries require
replacement. Remove the acre counter from the
implement and undo the 4 screws on the back of the case.
This will separate the housing from the rear plate.
Replace the batteries with 3 high quality AA alkaline
batteries.
Lubrication
WARNING
Do Not Lubricate Machine While Machine Is In
Motion. If Any Guards Are Removed for
Lubricating. They Must Be Replaced Before
Operating.
• Grease all fittings every 20 hours of operation. Each of
the four flangette bearings supporting the rollers has a
grease fitting. See Figure 4-1.
• Greaseable components are the same on each side,
right side shown.
• Lubricate Roller Chains periodically with quality chain
oil.
For best penetration, lubricate chain immediately after
use while chain is still warm.
4-2
TABLE OF CONTENTS
NOTE
It is good machine maintenance practice to check all bolts
for tightness during regular lubrications. Tighten any
fasteners that may have loosened during operation.
(Guard removed
for clarity)
GREASE
(Both Left & Right Sides)
Figure 4-1: Lubrication Fittings
GREASE
(Both Left &
Right Sides)
7K458-0221