Safety Decals - Landoll Brillion LSP5 Operator's Manual

Safety Decals

WARNING
MOVING PART HAZARD
TO PREVENT SERIOUS INJURY FROM
MOVING PARTS:
KEEP COVERS CLOSED DURING OPERATION.
DO NOT ALLOW ANYONE TO RIDE OR CLIMB
MACHINE DURING OPERATION.
KEEP OBSERVERS AWAY.
ITEM 1
2K123
CAUTION
BE SURE TO ENGAGE
PARKING PIN ON LEFT END OF
FRAME BEFORE UNHITCHING
TRACTOR. OTHERWISE
FRAME WILL TIP BACKWARDS
ABOUT FRONT AXLE
ITEM 3
9J302
IMPORTANT
DISENGAGE CLUTCH (IF SO
EQUIPPED) OR RAISED SEEDER
BEFORE BACKING UP.
FAILURE TO DO SO WILL
DAMAGE BRUSH AGITATORS.
ITEM 4
5D505
PARKING PIN
ITEM 7
9J301
1-4
TABLE OF CONTENTS
1. DO NOT LUBRICATE, ADJUST OR REPAIR WHEN MACHINE IS IN MOTION.
2. DO NOT TOW OR TRANSPORT FASTER THAN 15 MILES PER HOUR.
3. DO NOT RIDE OR ALLOW OTHERS TO RIDE ON THE MACHINE.
4. BLOCK UP ALL HYDRAULICALLY OR MECHANICALLY RAISED COMPONENTS TO PREVENT
UNINTENDED LOWERING OR LOWER THE MACHINE TO THE GROUND TO MAKE ADJUSTMENT
OR REPAIRS OR WHEN NOT IN USE.
5. KEEP ALL PERSONS AWAY FROM MACHINE DURING HITCHING AND OPERATING.
6. SLOW DOWN BEFORE MAKING SHARP TURNS OR USING THE BRAKE.
DRIVE SLOWLY OVER ROUGH GROUND, SIDE HILLS, AND AROUND CURVES TO AVOID TIPPING.
7. COMPLY WITH ALL LAWS WHEN TRANSPORTING THE MACHINE ON PUBLIC ROADWAYS.
8. INSTRUCT ALL OPERATORS IN THE SAFE OPERATION OF THE MACHINE.
REVIEW THE OPERATOR'S MANUAL FOR CORRECT PROCEDURES.
9. BLOCK IMPLEMENT TO PREVENT MOVEMENT WHEN UNHITCHED FROM TRACTOR.
10. KEEP ALL GUARDS AND SHIELDS IN PLACE WHILE MACHINE OR PARTS ARE IN MOTION.
2K123
ITEM 5
528933
ITEM 6
9J302 528938
ITEM 11
528934
Figure 1-2: Decals
CAUTION
ITEM 2
8J310
CALIBRATION
MACHINE MAY BE CALIBRATED FOR UNLISTED SEED AS FOLLOWS: 1. RATES ARE BASED UPON USING 13 TOOTH DRIVER SPROCKET. DOUBLE THESE VALUES
WHEN USING 26 TOOTH DRIVER SPROCKET.
1. RAISE MACHINE AND LOCK IN TRANSPORT POSITION. 2. RATES ARE INTENDED AS A GUIDE ONLY. VARIATIONS IN SIZE AND CLEANLINESS WILL
2. PLACE A CANVAS OR TARP ON GROUND TO CATCH SEED. AFFECT RATES. CHECK ACREAGE AND POUNDS OF SEED USED FOR BEST RESULTS.
3. TURN 3/4 HEX ON SPROCKET SHAFT COUNTERCLOCKWISE(CCW)
279 REVOLUTIONS FOR 5 FOOT SEEDER
232 REVOLUTIONS FOR 6 FOOT SEEDER.
4. WEIGH SEED AND MULTIPLY BY 10 FOR 13 TOOTH DRIVER
SPROCKET AND BY 20 FOR 26 TOOTH DRIVER SPROCKET TO GET
APPROXIMATE PLANTING RATE IN POUNDS PER ACRE.
17 TOOTH
IDLER
26 TOOTH
13 TOOTH
DRIVEN
3/4 HEX
13 TOOTH
OR
26 TOOTH
DRIVER
7K343 FOR LSP5 AND LSP6 SEEDERS
ITEM 8
7K343
ITEM 9
4K036
ITEM 10
7K341
ITEM 10
8K487
8J310
PLANTING RATES
7K458-0221