Landoll Brillion LSP5 Operator's Manual page 15

Acre Meter Kit 6K036 Installation
The Acre Meter Kit consists of four main parts; Acre Meter
Assembly, Pick-up Switch Bracket, Pick-up Switch, and
Magnet Wheel.
1. Drill 13/32" holes into seedbox at location shown. See
Figure 2-7.
2. Next, use 3/8-16 NC x 1" capscrews, lock washers,
and nuts to attach the bracket which holds the Acre
Meter, as shown, onto the left front of the seedbox.
3. Mount the Acre Meter onto this bracket with #10-24 x
1" machine screws, lock washers and nuts.
Acre Meter
Assembly
Capscrew,
3/8-16 X 1"
FRONT
7K458-0221
TABLE OF CONTENTS
4. Run the wire from the bottom of the meter down the
Machine Screw,
#10-24 X 1"
Lock Washer, 3/8"
Nut, 3/8"
Nut, #10-24
#10
Lock Washer
Figure 2-7: Acre Meter Installation (1 of 2)
side of the seedbox and along its left side. Use
mounting bases to hold the wire in place. Run it
across the plate which attaches the seedbox to end
plate. Here, it will plug into the mating cable from the
pick-up.
WARNING
Do not pressure clean with air or water.
Drill 13/32"
Holes
Mounting
Base
Acre Meter
Cable
Pick-up Box
Cable
2-5