Operation - Landoll Brillion LSP5 Operator's Manual

Landscape Seeder Operation
The Brillion Landscaper Seeder is fully assembled from
the factory. This section refers to how to successfully
operate your machine. Refer to the parts catalog for
complete part breakdowns. Be sure to read and
understand the Safety Procedures and Cautions starting
on Page 1-2.
"Left" and "Right" designation is determined by facing the
direction the machine will travel during field operation,
unless otherwise stated.
• If pre-assembled parts or fasteners are temporarily
removed, remember where they go. It is best to keep
parts separated.
• Check that all working parts move freely, bolts are
tight and cotter pins are spread.
• Refer to the Torque Chart in Chapter 4 for proper bolt
torque values.
Note the different torque requirement for bolts with
locknuts. Refer to "General Torque Specifications" on
page 4-1.
Front rollers crush lumps, press down small stones and
form a firm seedbed. Precision seeding devices meter out
the seed onto the well prepared seedbed. Rear rollers split
the shallow ridges formed by the front rollers and gently
firm the soil around the tiny seeds.
7K458-0221
TABLE OF CONTENTS
Figure 3-1: Landscape Grass Seeder Concept
DANGER
DANGER
Always be sure the front of the tractor has
enough weight to maintain control when the
machine is raised.
WARNING
When transporting on roadways, obey all
applicable laws and regulations.
Do not transport at speeds over 20 mph under
good conditions. Never travel at a speed which
does not allow adequate control of steering or
stopping.
Avoid sudden stops or turns because the weight
of the machine may cause the operator to lose
control of the tractor.
Make sure your slow moving vehicle sign is
clean and visible.
Chapter 3

Operation

3-1