Table of Contents
Advertisement
2
User Guide V
IU 6400-S Converged Network Appliance
Read-only User
Enabling a Read-only User
3 - 4
Menu
Network
VoIP ALG
Firewall
System
This feature works by creating a new user with read-only access to the
system. All information is displayed in a non-changeable form. Information
changed in entry boxes cannot be submitted. In fact, most Submit and OK
buttons are not visible.
Note: You must have administrator privileges and log in as an administrator
to change read-only user.
To enable a read-only user, use the following steps:
1. Using the configuration graphical user interface, from the Configuration
Menu on the left-hand side, click Network.
Note: You must have administrator access and log in as an administrator
to change read-only user.
2. Scroll down to the area of the screen shown below.
Description
Through the Network page, you can
configure a wide range of multimedia
network services. These services can be
enabled or disabled depending on the
functionality required for a network
configuration. The device's network
settings include configuring the Subscriber
and Provider interfaces, DNS and Default
Gateway.
Using the VoIP ALG page, you can
configure the connectivity and
management for Subscriber and Provider
voice and video over IP devices.
Through the Firewall page, you can
configure the 6400-S to act as a firewall
for voice, video and data traffic.
Through the System menu you have
access to a variety of configuration
operations and status information.
Advertisement
Table of Contents
