Read-Only User; Enabling A Read-Only User - Polycom V2IU 4350 User Manual

Note

Read-only User

Enabling a Read-only User

The new password must be between 6 and 20 characters in length. Any
combination of alpha and numeric characters is accepted.
1. Enter the password you chose in step C again in the Confirm Password to
ensure that there were no mistakes in the initial entry.
2. Press Submit.
This feature works by creating a new user with read-only access to the system.
All information is displayed in a non-changeable form. Information changed
in entry boxes cannot be submitted. In fact, most Submit and OK buttons are
not visible.
Note: You must have administrator privileges and log in as an administrator
to change read-only user.
To enable a read-only user, use the following steps:
1. Using the configuration graphical user interface, from the Configuration
Menu on the left-hand side, click Network.
Note: You must have administrator access and log in as an administrator
to change read-only user.
2. Scroll down to the area of the screen shown below.
3. Click changed. The following window screen appears:
Configuring the V2IU 4350
3 - 25