Hayward OmniLogic Troubleshooting Manual page 32
Consumer network troubleshooting
Hide thumbs
Also See for OmniLogic:
- Troubleshooting manual (50 pages) ,
- Installation manual (44 pages) ,
- How-to manual (12 pages)
Table of Contents
Advertisement
2. Wi-Fi Connection: "MSP Not Found" (cont.)
NOTE: If experiencing trouble logging into the web account, verify the username and
password are correct (the password IS CASE SENSATIVE).
Log into OmniLogic account
Step 2Q
Go to
www.haywardomnilogic.com
and complete login.
IF login was unsuccessful, verify the your internet is not
down and contact tech support (908) 355-7995. IF login
was successful, please contact a network professional
for more assistance*.
*IF an IP address appears after connecting to a hotspot then the problem is likely related to:
Firewall, IP conflict, port prioritization, parental controls, corrupt config., or Wi-Fi signal is
unreliable.
32
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OmniLogic and is the answer not in the manual?
Questions and answers
CHLOR Relay K1 and K2 Stuck Closed Chlorinator alarm
To fix the CHLOR Relay K1 and K2 stuck closed alarm on a Hayward OmniLogic system, try the following steps:
1. Power Cycle the System – Turn off the OmniLogic system, wait a few minutes, then turn it back on to see if the error clears.
2. Check for Physical Relay Issues – Inspect the relays for any visible damage or signs of burning.
3. Replace the 4A Fuse – If the error is intermittent, replacing the 4A fuse may help resolve the issue.
4. Update Firmware – Ensure the OmniLogic system is running the latest firmware, as updates may fix known issues.
5. Inspect Wiring and Connections – Verify that all wiring connections to the relays and T-Cell current sensor are secure and properly connected.
6. Monitor Error Behavior – If the error disappears and returns intermittently, it could indicate a failing relay that may need replacement.
If the issue persists after these steps, consider contacting Hayward support for further troubleshooting or relay replacement.
This answer is automatically generated