Hayward OmniLogic Troubleshooting Manual page 2
Consumer network troubleshooting
Hide thumbs
Also See for OmniLogic:
- Troubleshooting manual (50 pages) ,
- Installation manual (44 pages) ,
- How-to manual (12 pages)
Table of Contents
Advertisement
Hazardous voltage can shock, burn, cause serious injury
and or death. To reduce the risk of electrocution and or
• Only qualified technicians should remove the dead front
2
Safety Precautions
High Voltage Electrocution Hazard
electric shock hazards:
• Qualified technicians should: replace damaged
wiring immediately
• Qualified technicians should: Insure panel is properly
grounded and bonded
Warning
!
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OmniLogic and is the answer not in the manual?
Questions and answers
CHLOR Relay K1 and K2 Stuck Closed Chlorinator alarm
To fix the CHLOR Relay K1 and K2 stuck closed alarm on a Hayward OmniLogic system, try the following steps:
1. Power Cycle the System – Turn off the OmniLogic system, wait a few minutes, then turn it back on to see if the error clears.
2. Check for Physical Relay Issues – Inspect the relays for any visible damage or signs of burning.
3. Replace the 4A Fuse – If the error is intermittent, replacing the 4A fuse may help resolve the issue.
4. Update Firmware – Ensure the OmniLogic system is running the latest firmware, as updates may fix known issues.
5. Inspect Wiring and Connections – Verify that all wiring connections to the relays and T-Cell current sensor are secure and properly connected.
6. Monitor Error Behavior – If the error disappears and returns intermittently, it could indicate a failing relay that may need replacement.
If the issue persists after these steps, consider contacting Hayward support for further troubleshooting or relay replacement.
This answer is automatically generated