Table of Contents
Advertisement
Function
Sequence of operations 1. Enter the menu by typing a supervisor code.
Exit from the menu item 1. After you have performed the setting, press the MENU
Exit from the menu
46
7.11. Analoge output signal setting (14. menu item)
In this menu item you can choose between 4-20 mA and
0-20 mA output current. [Factory default: 4-20 mA]
The way the code should be type is described in Chapter
7.1. Typing the code in. You see on the display:
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. You see this:
blinking, signaling that it can be modify
5. Pressing ▲ button you can choose between the two
output signal:
•
: 4-20 mA current output [Factory default]
•
: 0-20 mA current output.
button. This takes you out from the menu item, and you see
this:
.
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the Sequence of
operations.)
(3. If you do not want to exit from the menu because you
want to perform other settings too, you may press the ▲
button to select the desired menu item.)
Press the MENU button. First the mnemonic
then the mnemonic
With this the storing of the settings is completed. The
instrument has exited the menu and goes on with the
measurement.
(Analog = analog).
on the display The text is
(Exit) are shown on the display.
DT4260 xx xx xx xx
.
(Save),
20111006-V020111006
Advertisement
Table of Contents
