Table of Contents
Advertisement
DT4260 xx xx xx xx
Function
MODBUS slave address
setting
Sequence of operations
20111006-V0
7.14. MODBUS communication settings (17. menu item)
Communication output with MODBUS RTU slave protocol.
The instrument can be connected to the PLC or to the
computer.
Here you can find how to set communication parameters.
Note 1:
When no communication option is installed than these
parameters are indifferent.
Note 2:
You have to set at the PLC or at the computer the same
communication parameters as here.
Enter the menu by typing a supervisor code.
The way the code should be type is described in Chapter
7.1. Typing the code in. You see on the display:
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. The mnemonic:
MODBUS cím) is shown on the display. Here you can set
the MODBUS slave address. Enter the menu item by
pressing the ENTER button.
5. You will see:
is blinking, signaling that it can be modify.
6. Pressing the ► button you can select the next digit.
7. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
8. After setting the MODBUS slave address, press MENU
button. The address range is: 0-247, if you set greater
number you will see
address will be set to 247. When you set 0 MODBUS
address the MODBUS communication will be switched off.
[Factory setting.]
Pressing the MENU button you will see:
instrument exits from the menu item.
(MODBUS).
(MODBUS Address =
on the display. The number on the left
,
,
,
,
,
error message and the
,
, etc.
and the
.
51
Advertisement
Table of Contents
