Datcon DT4260 Series Operating Instructions Manual page 20

Checking the
connections
Put the instrument
under supply voltage
20
Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).
Put the instrument under supply voltage
After you have completed the connections, put the
instrument under supply voltage. If the supply connection is
correct the display gives light.
The factory default value of the current transformer ratio is 1
i.e. the instrument displays the value of the input current
(the secondary current of the current transformer).
Setting the current transformer ratio you can find in
Chapter 7.
DT4260 xx xx xx xx
20111006-V020111006