Table of Contents
Advertisement
Setting the operating
mode
Sequence of operations
Exit from the operating
mode menu item
38
•
: (Outside) The output gets switched on, when
the displayed physical value isn't between the low limit
value (L.LI) and the high limit value (H.LI).
•
(Warm) The output gets switched on, when the
displayed physical value is lower than the low limit value
(L.LI), When the displayed current value is higher or equal
than L.LI, than the state of output doesn't change.
The output gets switched off when the displayed current
value is higher than the upper limit value (H.LI). When the
displayed current value is lower or equal than H.LI, than the
state of limit output doesn't change.
This operating mode is used in other DATCON instruments.
Here you can use it at any control task where the AC
current is the process value and you can control the
process through the limit outputs.
•
(Cool) The output gets switched on, when the
displayed physical value is higher than the high limit value
(H.LI). When the displayed current value is lower or equal
than H.LI, than the state of limit output doesn't change.
The output gets switched off when the displayed current
value is lower than the lower limit value (L.LI). When the
displayed current value is lower or equal than L.LI, than the
state of limit output doesn't change.
This operating mode is used in other DATCON instruments.
Here you can use it at any control task where the AC
current is the process value and you can control the
process through the limit outputs.
•
: (On = switched on) The output is switched on
independently from the measured value.
6. After selecting the limit output mode press MENU button
you will see:
7. If you had selected the
need to do any further settings. For finishing the operation,
please go on from the point Exit from the menu item.
.
or the
mode, there is no
DT4260 xx xx xx xx
20111006-V020111006
Advertisement
Table of Contents
