Clear Minimum And Maximum Values (14. Menu Item) - Datcon DT9000 Operating Instructions Manual

Function
Sequence of operations 1. Enter the menu by typing the supervisor code.
Exit from the menu item 1. After you have performed the setting, press the MENU
Exit from the menu
60
7.16. Clear minimum and maximum values
(14. menu item)
To clear the measured and stored mimimum and maximum
values.
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see this on the display:

.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. The mnemonic
mnemonic is blinking.
Now you still have the possibility to exit. If you want to exit,
as you do not want to clear the minimum and maximum
values after all, press the MENU button. This takes you out
from this menu item, and you see this:
5. If you want to clear the minimum and maximum values,
press the ▲ button to change the „NO" to „YES".

•
 = I do not want to clear

•
 = I want to clear
button. This takes you out from the menu item, and you

see this: .
(2. If you do not want to exit from the menu because you
want to perform other settings too, you may press the ▲
button to select the desired menu item.)
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.

.

is shown on the display. The


.

(Exit) are shown on the
20171205-V2
DT9000