Table of Contents
Advertisement
DT4260 xx xx xx xx
Function
Sequence of operations 1. Enter the menu by typing the supervisor code.
20111006-V0
7.12. Assignment analog output low value to display
value (scaling) (15. menu item)
Here you can assigne analog output low value
(0 mA or 4 mA) to the display (AC current) value. This way
you can assigne any phisical range to any output range.
[Factory default: 000.00. so in case of 0 A display value the
output value will be 4 mA (or 0 mA).]
Notice! For scaling the analog output it must be assigne the
analog output high value also. (Next menu item)
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see this on the display:
.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
scale low value).
3. Enter the menu item by pressing the ENTER button.
4. The number:
number is blinking, signaling that it can be modify.
5. Pressing the ► button you can select the next digit.
6. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
7. When the digit on the left side is selected pressing the ▲
button the sequence is as follows:
,
,
,
,
can set any number between -9999-99999.
.(Analog Scale Low = analog
. is shown on the display. The
,
,
,
,
,
,
,
,
,
,
,
, etc.
,
,
, etc. so you
47
Advertisement
Table of Contents
