Checking Hydraulic Oil Tank Level; Checking Coolant Level - Kubota RTV-X900G Operator's Manual

66 PERIODIC SERVICE
BChecking Hydraulic Oil Tank Level
1. Park the vehicle on a level surface.
2. Stop the engine.
3. Open the seat.
4. Remove the rubber cap.
5. To check the oil level, remove the dipstick, wipe it
clean, screw it into filling hole and remove dipstick
again.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Filling plug with dipstick
A If oil level is low, do not run engine.
(A) Oil level is acceptable within
this range
BChecking Coolant Level
To avoid serious injury:
A Do not remove radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Park the vehicle on a level surface.
2. Stop the engine.
3. Open the hood.
4. Check to see that the coolant level is between the
"FULL" and "LOW" marks of recovery tank.
5. When the coolant level drops due to evaporation, add
water only up to the full level.
In case of leakage, add anti-freeze and water in the
specified mixing ratio up to the full level.
(See "Flush Cooling System and Changing Coolant" in
"EVERY 2 YEARS" in "PERIODIC SERVICE"
section.)
(1) Radiator cap
(2) Recovery tank
A If the radiator cap has to be removed, follow the
caution above and securely retighten the cap.
A Use clean, fresh water and anti-freeze to fill the
recovery tank.
A If water should leak, consult your local KUBOTA
Dealer.
(A) "FULL"
(B) "LOW"