Cleaning Air Cleaner Primary Element; Adjusting Alternator Belt Tension - Kubota RTV-X900G Operator's Manual

BCleaning Air Cleaner Primary Element
1. Remove the air cleaner cover and primary element.
2. Clean the primary element:
(1) When dry dust adheres to the element, blow
compressed air from the inside, turning the
element. Pressure of compressed air must be
under 205 kPa (2.1 kgf/cm ).
(2) When carbon or oil adheres to the element,
replace the element with new one even if it has
not been used for 1 year.
3. Replace the primary element:
Once yearly or after every sixth cleaning, whichever
comes first.
A Check to see if the evacuator valve is blocked with
dust.
A Check the rubber seal. Replace if damaged.
(1) Secondary (safety) element
(2) Primary element
(3) Rubber seal
(4) Evacuator valve
(5) Cover
A The air cleaner uses a dry element, never apply oil.
A Do not run the engine with filter element removed.
A Be sure to refit the cover with the arrow (on the rear of
cover) upright. If the cover is improperly fitted,
evacuator valve will not function and dust will adhere
to the element.
A Do not touch the secondary element except in cases
where replacing is required.
C Evacuator Valve
Open the evacuator valve once a week under ordinary
conditions - or daily when used in a dusty place - to get rid
of large particles of dust and dirt.
PERIODIC SERVICE
BAdjusting Alternator Belt Tension
To avoid serious injury:
A Be sure to stop the engine before checking belt
tension.
Proper A deflection of between 7 to 9 mm
alternator belt when the belt is pressed in the middle
tension of the span.
1. Park the vehicle on a flat surface, open the seat and
remove the maintenance cover.
2. Stop the engine.
3. Apply moderate thumb pressure to belt between
pulleys.
4. If tension is incorrect, loosen the alternator mounting
bolts and, using a lever placed between the alternator
and the engine block, pull the alternator out until the
deflection of the belt falls within acceptable limits.
5. Replace alternator belt if it is damaged.
(1) Bolt
75
(A) Check the belt tension
(B) To tighten