Every 400 Hours; Changing Front Knuckle Case Oil; Changing Transmission Fluid - Kubota RTV-X900G Operator's Manual

90 PERIODIC SERVICE

EVERY 400 HOURS

BChanging Front Knuckle Case Oil
1. Park the vehicle on a firm, flat and level surface.
2. Remove the tire.
3. To drain the used oil, remove the drain and filling plugs
at the left hand knuckle case and drain the oil
completely into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with the new oil up to the filling port level.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
6. After filling, reinstall the filling plug.
7. Use the same procedure to change the right hand
knuckle case oil.
Oil capacity (one side)
8. Properly dispose of used oil.
(1) Drain plug
(2) Filling plug
BChanging Transmission Fluid
1. Park the vehicle on a level surface.
2. Raise the cargo bed and mount the safety support.
3. To drain the used oil, remove the drain plug at the
4. After draining, reinstall the drain plug.
5. Fill with the new KUBOTA UDT or SUPER UDT fluid
Ref. 0.25 L
6. After running the engine for a few minutes, stop the
7. Properly dispose of used oil.
(1) Oil inlet
(2) Dipstick
To avoid serious injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
bottom of the transmission case and drain the oil
completely into the oil pan.
up to the upper cross hatched area on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
engine and check the oil level again; add oil to
prescribed level.
Oil Capacity
(A) Oil level is acceptable within this range.
7.0 L