Engine Mount Arm Assembly & Installation - Peco 22131501 Operator's Manual

Engine Mount Arm Assembly & Installation
Engine Drive
Engine Driven Unit Instructions
Position the Outer Engine Mount Tube (Item #1) above the tab of the Rear Frame Bracket aligning the Outer Tube
between the two sets of mount holes as shown in Figure A. Secure the Outer Engine Mount Tube, relatively loose, by
using (2) 3/8"-16 x 2-1/8" U-Bolts (Item #2) and (4) 3/8"-16 Ny-Flange Lock Nuts (Item #3). Once secured, adjust the
Outer Engine Mount Tube positioning by moving it to the right until the right edge protrudes no more than 2-1/2" from
the side of the Rear Frame Bracket. Once adjusted, tighten all hardware.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A
Insert the Engine Mount Arm Assembly (Item #1) into the Outer Engine Mount Tube (Item #2) and position the
mounting pin hole between the two parts. Secure the Engine Mount Arm Assy by using (1) Detent Pin (Item #3). Refer
to Figure B below.
Figure B
16