Wire Harness Installation (Continued)
Next, route the Negative Lead (-) and the Positive Lead (+) of the Wire Harness P#(P0298) (Refer to Figure C) to the
negative & positive terminal of the mower's battery. Then, disconnect the mower's clutch connector and interconnect
with the Wire Harness' Clutch Connection Jumper. Be sure to identify and pick the correct Jumper depending on your
mower's clutch connection type. Refer to the Wiring Diagram on Page 28 for the Connection Jumper Types.
Figure C
Finally, route the Wire Harness back towards the rear of the mower positioning the Wire Harness under the Right
Frame Bracket / Lower. Then connect the Wire Harness to the PTO Unit. Refer to Figure D.
Note: It is recommended to secure the Wire Harness to the mower by using the (8) included Cable Ties P#(J0245)
once you have the Wire Harness installed. Be sure the Wire Harness is routed so that it does not obstruct the seat as
it is being lowered down or any part of the mower that may damage the Harness.
Figure D
Right Frame
Bracket / Lower
28
Positive Lead (+) to
Positive Terminal (+)
Wiring Harness
Battery Terminal
Connection
Negative Lead (-) to
Negative Terminal (-)
Note: To avoid damage to the Wire Harness,
do not leave any slack that will allow the Wire
Harness to come into contact with the PTO Belt
Route Wire Harness to PTO-X Unit
PTO-X