Bag Assy; Bag Assy Installation - Peco 22131501 Operator's Manual

Bag Assembly
First, take one of the Bag Ring Split Ends and insert it through the Bag Seam Opening. Next, rotate the Bag around
the Bag Ring (1) full turn (360 degrees) until the Bag Ring Split Ends and the Bag Seam Opening are positioned on
the same side. Then, connect the Bag Ring Split Ends using (1) End Connector. Last, rotate the Bag Ring and the
End Connector Assembly (1/2") turn (180 degrees) to position the Connector opposite of the Bag Seam Opening.
Note Final End Connector Location below in Figure A. Repeat for each Bag.
Figure A
End
Connector
Mesh
Panel
Bag
Bag Assembly Installation
Slide the Completed Bag Assembly into the Upper Frame Assembly Rails and close the Top Assembly. Fasten the
Draw-Latch on either side to hold the bagger closed.
Bag Ring
Bag Ring
Split Ends
Nylon
Panel
Mesh
Panel
Bag Seam
Opening
Top Assembly
Draw-Latch
Upper Frame
Assembly
Rail
Completed
Bag Assembly
Note Final
End Connector
Location
25