Peco 22131501 Operator's Manual page 34

Quad Weight Kit Installation
Installation on Left Caster
Position the Quad Weight Bracket (Item #1) under the caster as seen in Figure A. Align the (3) holes of the Dual
Weight Bracket (Item #1) to the holes in the caster.
F asten the Weight Bracket to the caster using
3/8"-16 Ny-Flange Lock Nuts (Item #3.6), (1) 1/2"-13 x 1-1/4" HHCS (Item #3.7), (1) 1/2" Flat Heavy Washer (Item
#3.8) & (1) 1/2"-13 Nyloc Nut (Item #3.9). One set of 3/8" fasteners in the front right and one set of 3/8" fasteners in
the rear, behind the caster. See Figure A & Figure B.
Insert (2) Weights (Item #2) Into the front of the Quad Weight Bracket & align the mount hole of the Weights w/ the
hole on the Weight Bracket tab. Fasten the Weight to the Weight Bracket using (1) Clevis Pin (Item #3.1), (1) 1/2" Flat
Washer (Item #3.2) & (1) Hair Pin Clip (Item #3.3) PER SIDE. See Figure B.
Figure A
(1) 1/2"-13 x 1-1/4" HHCS
(1) 1/2" Flat Heavy Washer
(1) 1/2"-13 Nyloc Nut
Note: Slide the 1/2"-13 x 1-1/4" HHCS
to the end of the slot as shown
Figure B
34
(2) 3/8"-16 x 1" HHCS (Item #3.4), (2) 3/8" Flat Washers (Item #3.5), (2)
(1) 3/8"-16 x 1" HHCS
(1) 3/8" Flat Washers
(1) 3/8"-16 Ny-Flange lock Nuts