Dump Mechanism Adjustment; Engine Mount Arm Installation - Peco 06742408 Operator's Manual

Dump Mechanism Adjustment

The linkage rods may be adjusted at the adjusting screw and at the latch assembly. To change the door closure
tightness, thread the adjusting screw clockwise to loosen the contact between the door and the box, or counter-
clockwise to tighten the contact between the door and the box.
To adjust the latch, change the length of the latch rod by threading the latch rod in or out of the adjusting ball joint.
The latch hook pivot should be in the middle of the slot in the latch hook pivot plate. Slide the pivot back and forth,
then tighten so the door opens and closes while still having a tight seal between the door and the box. See Figure A.
Figure A
Latch Rod
Adjusting Ball Joint

Engine Mount Arm Installation

Slide the Engine Mount Assembly P#(A2022_01) behind the front right wheel and in front of where the battery housing
cover was located. Fasten the Engine Mount Assembly to the frame by using (2) 1/2"-13 x 4-5/16 x 2-3/4 U-Bolts
P#(K0289) around the frame and into the bolt holes on the Mount Plate and secure with (4) 1/2"-13 Ny-Flange
Locknuts P#(K2012). See Figure B.
Figure B
(2) 1/2"-13 x 4-5/16" x 2-3/4" U-Bolts
(4) 1/2"-13 Ny-Flange Locknuts
14