Table of Contents
Advertisement
Engine Drive Assembly Installation
Engine Driven Unit Instructions
First, place (2) Rubber Shock Absorbers (Item #3) on top
of the Engine Mount Arm Assembly (Item #2) aligning
the bolt holes of the Rubber Shock Absorbers to those
on the Engine Mount Arm Assy.
Next, position and place the 6.5HP Engine Assembly
(Item #1) on top of the Shock Absorbers aligning the bolt
holes of all the components.
Finally, secure the Engine by using (4) 5/16"-18 x 2"
HHCS (Item #4) and (4) 5/16"-18 Nyloc Nuts (Item #5).
Refer to Figure A.
Note: Some parts and part features have been hidden
from view for visual clarity.
Blower Cone Installation
Thread (1) 5/16"-18 Jam Nut P#(K0120) onto each end
of (2) 5/16"-18 x 2-1/2" HHCS P#(K0125) as shown in
Figure B.
Figure B
Thread (1) Jam Nut
Onto Each 5/16"-18 Bolt
Now partially thread (1) bolt into each of the two
threaded bosses located on the Blower Housing. Place
8" Blower Cone P#(E6009) so the two tabs line up with
the bolts and tighten completely as shown in Figure C.
Figure C
Threaded
Boss
Figure A
Once the (2) bolts are tight, tighten the Jam Nuts against
the threaded boss as shown in Figure D.
(2nd) Tighten
Jam Nut
Refer to Figure E for proper Blower Cone installation
reference.
Figure E
Blower
Cone Tab
Blower
Cone
Figure D
Engine Drive
(1st) Tighten
Bolt
17
Advertisement
Table of Contents
