Housing Versions - Siemens SIMEAS R-PMU Manual

4

4.8 Housing Versions

4.8 Housing Versions
Designs
The SIMEAS R-PMU is available in two different designs depending on the application.
Central unit ZE 8/16 (10-inch housing) with 1 DAU slot, flush or surface mounted housing
Central unit ZE 32/64 (19-inch housing) with 4 DAU slots, flush or surface mounted housing
Slot 1 is reserved for the CPU, always the last slot from the power supply unit. The remaining
slots can be equipped with the different data acquisition units (DAUs).
The modules are installed vertically in the frame and can be changed from the front side. The
terminals are located at the rear of the frame.
View
The front and the rear view of a ZE 8/16 with a CDAU are shown here as an example.
Display of operational
conditions (LEDs)
Buttons for manual
trigger, test mode,
blocking mode, etc.
Figure 4-5 SIMEAS R-PMU (ZE 8/16): front and rear view (flush mounted housing)
32
Switch Connection for
On/Off mains supply
Analog
Front interface
measurement
(COM S)
channels
Digital Fault Recorder, SIMEAS R-PMU, Manual
Message inputs
and outputs
Binary Interfaces for
measurement printer (LPT 1)
channels and external modem
(COM 1)
E50417-H1076-C360-A5, Release 10.2012
LAN
interface