Siemens SIMEAS R-PMU Manual page 178

13
13.2 Operator and Error Messages
Table 13-2 shows the allocation of LEDs 9 to 21 at delivery and describes the meaning of the
individual operator messages.
Table 13-2 Operator messages via LEDs
LED no.
9 Device ready for operation
10 Supply voltage OK
11 Battery buffer OK
12 Recording active
13 Device synchronized
14 Communication active
15 Ring buffer active
16 PMU active
17 Group alarm
18 Normal mode
19 Lock mode
20 Test mode
21 Manual triggers
178
Message Definition
Device is ready for operation, no malfunctions
Supply voltage is present
Battery buffer operating without malfunctions
(optional)
Is lit for the duration of a triggered fault recording
(TAR or TPR) - not with trigger cause "external
start"
LED flashes: a valid synchronization signal has
been detected, however, the device is not
synchronized yet;
LED lights up:device is synchronized
A communication has been set up by OSCOP P
Records are deleted because ≥90 % of the
reserved memory space has been reached
LED flashes: PMU recording is active, however,
no PMU data is transferred to the PDC;
LED lights up: PMU recording is active and PMU
data is transferred to the PDC
Device has malfunctioned
Device is in normal mode, all triggers are active
Device is in lock mode, all triggers are deactivated
Device is in test mode, all triggers are active;
"Test" is entered as trigger cause
Manual triggering of a record; "Manual" is entered
as trigger cause
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012