Siemens SIMEAS R-PMU Manual page 133

Note
When you parameterize a device for the first time, you will be asked if you want to create a new
parameter set or load the parameters from the device. Depending on your choice, the following
dialog displays no entries or the default device data.
Enter the hard disk capacity if you want to parameterize a SIMEAS R-PMU offline, i. e.
without connection to the device.
Figure 12-2 Dialog box for setting the SIMEAS R-PMU parameters
Note
The manufacturers of mass memories set the memory capacity 1 MByte = 1,000,000 bytes. The
real conversion is 1 MByte = 1,048,576 bytes, instead: You have to make sure to enter the
correct value under Hard disk capacity. Enter 970 MByte for a 1 GByte flash disk and 480
MByte for a 512 MByte flash disk.
To determine the flash disk size exactly, load the SIMEAS R-PMU parameters before starting
with the parameterization (see Load from device in this chapter). You will not be able to change
the parameter Hard disk capacity, when you determine the hard disk size this way.
The menu bar with the following commands is on top of the dialog box:
Copy device parameters
Build up a connection between the evaluation PC and the device
Transfer parameters into and from the device, read out status, send date and time, etc.
Load parameters from the DAKON/server
Load parameters from the database/store parameters in the database
Import/export parameters
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012
12
12.1 General
133