Siemens SIMEAS R-PMU Manual page 283

Log No. Type Class
1282 2 CALL_PC Callback PC was acknowledged by
1283 1 CALL_PC Callback PC repeated. Interface:
1536 2 BATTERY Start of battery monitoring process
1537 2 BATTERY Start of battery monitoring after startup.
1538 2 BATTERY Battery monitoring after startup OK
1539 0 BATTERY Fault in battery monitoring after startup.
1542 0 BATTERY Fault in battery monitoring during operation.
1543 2 BATTERY Continuous charging started.
1545 0 BATTERY Unable to charge battery or time-out
1547 1 BATTERY Battery fully discharged
1548 0 BATTERY Power supply failure,
1549 1 SYSTEM
1793 2 PANEL
1807 1 PANEL
1808 1 PANEL
1810 1 SYSTEM
1811 1 SYSTEM
1812 2 SYSTEM
1813 2 SYSTEM
1814 2 SYSTEM
1815 0 SYSTEM
1816 0 SYSTEM
1818 1 SYSTEM
1820 1 SYSTEM
1821 0 SYSTEM
1822 0 SYSTEM
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012
Description
OSCOP P. Interface:
Test time:
Remaining time:
Remaining time:
Charging time:
battery operation active
Reset initiated
Panel button pressed
External reset triggered
Recording interrupted, as data can no
longer be disposed of
Device ready
Power supply OK
OSCOP P communication
TAR/Analog fault recorder:
Recording event
TPR/Frequency power recorder:
Recording event
DAU fault
Printer fault
PC unreachable
Ring buffer active
Temperature has risen above permissible
value of +55 °C
Temperature has dropped below
permissible value of -5 °C
3 System Messages
Comment
-
Make sure that OSCOP P runs in automatic
mode and was parameterized to be able to
receive callbacks from this device.
Check the communication link and the
callback communication parameters if
necessary.
Cyclical battery test (will be started even
without battery)
-
-
-
-
-
-
-
-
-
-
Reset trigger via control input 3
-
Note: Some functions are ready for
operation with a delay (manual trigger,
network trigger)
-
-
-
-
DAU boot fault or DAU failure (self-
monitoring), hotline
Check printer, printer connection; fault
disappears after correction (takes approx. 5
minutes)
Make sure that OSCOP P runs in automatic
mode and was parameterized to be able to
receive callbacks from this device.
Check the communication link and the
callback communication parameters if
necessary.
90 % of the reserved TAR or TPR memory
size is reached, the oldest data will be
deleted up to 80 %.
-
-
283