14
14.3 Extending the Existing Hardware
14.3.4.2 Printer
To connect the printer, proceed as follows:
1.
Switch the SIMEAS R-PMU off using switch S1.
2.
Connect the printer connecting cable to the parallel interface PRINTER (LPT 1) at the rear
panel of the SIMEAS R-PMU (25-pin socket).
3.
Connect the cable to the printer.
4.
Connect the supply voltage to the printer.
5.
Switch the printer on.
6.
Switch the SIMEAS R-PMU on using switch S1.
7.
Connect the notebook to the service interface COM S at the front side of the SIMEAS R-
PMU.
8.
Enable the local print output using the OSCOP P system program. For detailed information
regarding the parameterization, please refer to Chapter 12.
Figure 14-7 LPT 1 interface
206
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012