Replacing The Diesel Engine's Oil Separator Filter - Fayat Group DYNAPAC CC1300 Translation Of Original Instruction Manual

Fig. Engine compartment
1. Oil separator filter
Fig. Oil separator filter
2. Cover
3. Filter insert and O-ring
4. Filter housing
102
Replacing the diesel engine's oil separator
filter
(applies to 1500h)
N.B. The engine must be switched off when
changing the filter.
Loosen the filter's bottom cover (2) and remove the
filter insert and O-ring (3).
1
4
3
Wipe out any deposits in the bottom cover (2) and filter
housing (4).
2
Fit the new filter insert with O-ring (3) and refit the
bottom cover (2).
Start the diesel engine and allow it to run at full revs
for 30 seconds. Check that the filter cap (2) is tight.
4812162001_D.pdf
Maintenance measures - 500 h
Remove the filter insert (3) and hand in to a Remove the filter insert (3) and hand in to a
waste disposal station. This is a disposable filter waste disposal station. This is a disposable filter
and cannot be cleaned. and cannot be cleaned.
2021-12-14