Table of Contents
Advertisement
1. Important safety information regarding the placement of this
device is provided on page 123. Please review it before
proceeding.
2. Make sure that the power to any device that you connect to the
installation has been turned off. You must unplug the power
cords of any computers that have the Keyboard Power On
function.
3. Any installation that does not follow the instructions in this
guide may be hazardous.
4. The power source for this product is intended to be supplied by a
power adapter only, not a DC mains.
Stacking and Rack Mounting
Stacking
The CN8600 can be placed on any appropriate leveled surface that can safely
support its weight plus the weight of its attached cables. To place or stack the
CN8600, remove the backing material from the bottom of the rubber feet that
came with this package and stick them onto the switch's bottom panel at its 4
corners, as shown in the diagram, below
Note: To ensure adequate ventilation, allow at least 5.1 cm on each side, and
12.7cm at the back for power cord and cable clearance.
Hardware Setup
Chapter 2
11
Advertisement
Table of Contents
