Table of Contents
Advertisement
Option
Video Quality
Enable Refresh
Transparency
Gray Level Control
Detect Tolerance
Click OK to save your changes and close the dialog box.
Click Cancel to abandon your changes and close the dialog box.
Note: For best results, change the gamma while viewing a remote computer.
Drag the slider bar to adjust the overall video quality. The larger
the value, the clearer the picture and the more video data goes
through the network. Depending on the network bandwidth, a
high value may adversely affect response time.
The CN8600 can redraw the screen every 1 to 99 seconds,
eliminating unwanted artifacts from the screen. Select Enable
Refresh and enter a number from 1 through 99. The CN8600 will
redraw the screen at the interval you specify. This feature is
disabled by default. Click to put a check mark in the box next to
Enable Refresh to enable this feature.
Note: 1. The switch starts counting the time interval when
mouse movement stops.
2. Enabling this feature increases the volume of video
data transmitted over the network. The lower the
number specified, the more often the video data is
transmitted. Setting too low a value may adversely
affect overall operating responsiveness.
Drag the slider bars to adjust the transparency of the remote
display.
Check the box and slide the bar to adjust the level of gray on the
remote display.
This setting also relates to video quality. It governs detecting or
ignoring pixel changes. A high setting can result in a lower quality
display due to less data transfer. A lower setting will result in
better video quality, but setting the threshold too low may allow
too much data to be transferred, negatively impacting network
performance.
Chapter 5. The Client Viewer
Usage
77
Advertisement
Table of Contents
