ATEN CN9000 User Manual page 56

CN8600 User Manual
Mode
Use this section to set the working mode parameters.
 Enable ICMP so that the CN8600 can be pinged. If it is not enabled, the
device cannot be pinged. The default is Enabled.
 Enable Multiuser Operation to permit more than one user to log into the
CN8600 at the same time. The default is Enabled.
 Enable Virtual Media Write allows redirected virtual media devices on a
user's system to send data to a remote server, as well as being able to have
data from the remote server written to them. The default is Enabled.
 Browser Service allows the administrator to limit the scope of browser
access to the CN8600. Put a check in the checkbox to enable this function,
then select the browser limitation in the drop down list box. Choices are
explained in the following table:
Item
Disable Browser
Disable HTTP
Disable HTTPS (SSL)
 If Disable Authentication is checked, no authentication procedures are
used to check users attempting to log in. Users gain Administrator access
to the CN8600 switch simply by entering combination of username and
password.
Note: Enabling this setting creates an extremely dangerous result as far as
security goes, and should only be used under very special
circumstances.
44
If this is selected, the CN8600 cannot be accessed via
a browser. It can only be accessed from the AP
programs (see AP Operation, page 91).
If this is selected, the CN8600 can be accessed via a
browser, but not from an ordinary (HTTP) login
connection – it can only be accessed over a secure
HTTPS (SSL) connection.
If this is selected, the CN8600 can be accessed via a
browser over an ordinary (HTTP) login connection, but
not via a secure HTTPS (SSL) connection.
Explanation