Bridge Setup Screen Fields; Selecting A Spanning Tree Protocol - Cabletron Systems MicroMMAC 22ES User Manual

Chapter 8: Bridge Setup Screen

8.1 BRIDGE SETUP SCREEN FIELDS

The following list describes each of the Bridge Setup screen fields:
Spanning Tree Protocol
Use this field to select a Spanning Tree protocol. Possible selections for
this field are IEEE 802.1, DEC, or NONE.
Bridge Port Admin Status
Use this field to enable or disable individual MicroMMAC bridge ports.
Possible selections for this field are ENABLED or DISABLED.
Bridge Port Pair Admin Status
Use this field to enable or disable bridging between bridge port pairs. For
example, you can enable Port 1 to bridge traffic to all ports except Port 2.
Bridge_Port X
Use this command field to select the MicroMMAC bridge port you want
to configure.

8.2 SELECTING A SPANNING TREE PROTOCOL

To select the Spanning Tree protocol to be used by the bridge, perform the
following steps:
1. Use the arrow keys to highlight the SPANNING TREE
PROTOCOL field.
2. Press SPACE or BACKSPACE to select [IEEE 802.1], [DEC], or
[NONE].
3. Use the arrow keys to highlight the SAVE command field.
4. Press ENTER. The Event Message field at the top of the screen
displays "SAVED OK."
Page 8-2 MicroMMAC Local Management User's Guide