Table of Contents
Advertisement
Chapter 5: SNMP Community Names Screen
5.1 COMMUNITY NAME ACCESS POLICY
In order to perform any operations on the SNMP Community Names
screen, you must have used the super-user community name at the User
Password prompt when initiating the Local Management session. The
default community name for each access level is public or press ENTER.
The following definitions explain each of the three levels of access:
read-only
This access level allows reading of device parameters not including
community names.
read-write
This access level allows editing of some device configuration parameters
not including changing community names.
super-user
This access level allows full management privileges.
5.2 SETTING SNMP COMMUNITY NAMES
To set a community name, perform the following steps:
1. Use the arrow keys to highlight the community name you want to
change.
2. Type the new community name and press ENTER. The old
community name text disappears and is replaced by the new
community name.
3. Use the arrow keys to highlight the SAVE command field.
4. Press ENTER. The Event Message field at the top of the screen
displays "SAVED OK."
If you edit the super-user community name, be certain you do
!
not forget it. If you do, you will be unable to perform Local
CAUTION
Management functions without returning the device to its
factory default configurations. This will effectively erase any
configuration work you may have done.
Page 5-2
MicroMMAC Local Management User's Guide
Advertisement
Table of Contents
