Table of Contents
Advertisement
Chapter 2: Local Management Requirements
2.2.2 Cable Configuration for the UPS
To configure a cable from the Uninterruptible Power Supply (UPS) to a
host device perform the following steps:
1. Plug a straight-through twisted pair, RS232, cable into the COM 1 or
COM 2 port.
2. Plug the other end of the RS232 cable into the adapter (Part No.
9372066) and connect the adapter to the UPS.
After the cable configuration is complete, use one of the following
management tools to configure the COM port for UPS application:
•
Local Management – Chapter 4, System Level Screen of this manual
provides instructions for setting up the COM 1 and COM 2 ports for
the UPS application.
•
Graphical user interfaces provided by SPECTRUM Element Manager
for Windows, SPECTRUM Portable Management Applications
(SPMAs), or SPECTRUM software packages.
2.3 ESTABLISHING A TELNET CONNECTION
Once the MicroMMAC has a valid IP address, you can establish a Telnet
session with Local Management from any TCP/IP based node on the
network. Telnet connections to the host device require the community
name passwords assigned at the SNMP Community Names screen. Refer
to the SNMP Community Names section of this manual for additional
information about community names.
See the instructions included with the Telnet application for
NOTE
information about establishing a Telnet session.
Page 2-4
MicroMMAC Local Management User's Guide
Advertisement
Table of Contents
