Table of Contents
Advertisement
This chapter explains how to use the Bridge Setup screen to select a
Spanning Tree protocol and enable/disable bridge ports. If the
MicroMMAC contains a Token Ring BRIM, the lower portion of the
Bridge Setup screen contains additional fields which relate to the
operation of Token Ring devices. Figure 8-1 shows the Bridge Setup
screen.
Token Ring bridge information does not appear in this manual
NOTE
but will be included with the next revision.
Event Message Line
MicroMMAC Local Management
SPANNING TREE PROTOCOL:
BRIDGE PORT ADMIN STATUS:
BRIDGE PORT PAIR ADMIN STATUS:
This section appears only if device is Token Ring or if Token Ring BRIM is installed.
SAVE
MicroMMAC Local Management User's Guide
CHAPTER 8
BRIDGE SETUP SCREEN
BRIDGE PORT TYPE
RING NUMBER (1-FFF):
HOP COUNT LIMIT (1-E):
SINGLE ROUTE BROADCAST:
FRAME TRANSLATION:
[BRIDGE_PORT XX]
Figure 8-1 The Bridge Setup Screen
BRIDGE SETUP
[IEEE 802.1]
PORT XX --> ALL PORTS
PORT XX --> PORT [YY]
[SRT]
001
7
[AUTO-SPAN]
[DISABLED]
Flash Image Version: XX.XX.XX
[ENABLED]
[ENABLED]
RETURN
Page 8-1
090835
Advertisement
Table of Contents
