Electrical Wiring - Gree U-MATCH Series Service Manual

①. The power source capacity must be the sum of the air conditioner current and the current of other electrical
appliances. When the current contracted capacity is insufficient, change the contracted capacity.
②. When the voltage is low and the air conditioner is difficult to start, contact the power company to raise the voltage.

4.2 Electrical Wiring

(1) For solid core wiring (Figure 3-2-10)
1) Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation about 25 mm
(15/16").
2) Using a screwdriver, remove the terminal screw(s) on the terminal board.
3) Using pliers, bend the solid wire to form a loop suitable for the terminal screw.
4) Shape the loop wire properly, place it on the terminal board and tighten securely with the
terminal screw using a screwdriver.
(2) For strand wiring (Figure 3-2-10)
1) Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation about 10 mm
(3/8")
2) Using a screwdriver, remove the terminal screw (s) on the terminal board.
3) Using a round terminal fastener or pliers, securely clamp a round terminal to each stripped wire
end.
4) Position the round terminal wire, and replace and tighten the terminal screw with a
screwdriver.( Figure 3-2-11)
A Solid wire
Screw with
special washer
Wire
Figure 3-2-11
(3) How to fix connection cord and power cord by cord clamp
After passing the connection cord and power cord through the insulation tube, fasten it with the cord
clamp. (Figure 3-2-12)
Insulation layer
Round
terminal
Terminal
board
U-Match Series DC Inverter Service Manual
CAUTION!
B Strand wire
Solderless
terminal
Figure 3-2-10
Screw with
special washer
Round
terminal
Wire
75
Insulation tube
Insulation tube
Cord clamp
Figure 3-2-12