Switch Installation; Unpacking The Switch; Accessory Carton Contents; Inspecting The Switch - Cabletron Systems SmartCell 6A000 Installation And Setup Manual

Enterasys smartcell 6a000: install guide

Hide thumbs Also See for SmartCell 6A000:

Table of Contents

2 SWITCH INSTALLATION

This chapter explains how to inspect and install your SmartSwitch 6A000 ATM switch module.

2.1

Remove the accessory carton from the SmartSwitch 6A000 shipping box. Carefully remove the switch from its

packing material.

2.1.1

Open the accessory carton and check that it contains the following items:

— 7-foot UTP cable, terminated on both ends with RJ-45 connectors

— RJ-45 to 9-pin female adapter (labeled PC)

— Console cabling instruction sheet

— CDROM containing the following:

SmartSwitch 6A000 operating firmware

SmartSwitch ATM switch documentation in Adobe Acrobat format

SmartSwitch ATM Administrator software

MIB files

SmartSwitch 6A000 Release Notes

Note

If any of these items are missing, contact Cabletron Global Support Center

immediately.

2.2

Depending on the configuration ordered, your switch looks similar to one of the units in the drawing in Figure 2-1. The

6A000-04, shown on the left, has four I/O modules. The 6A000-02, shown on the right, has two I/O modules; the

empty I/O module positions are covered by metal blanks.

SmartSwitch 6A000 Installation and Setup Guide 2-1

Table of Contents

Do you have a question about the SmartCell 6A000 and is the answer not in the manual?