Advertisement
Calibration
Thermo Scientific
The Calibration screen allows the user to calibrate the system, setup
automatic calibrations, and view calibration data. See Chapter 4
"Calibration" for further instructions on how to run a calibration.
The following screens show the calibration screens in single range mode
and dual or auto range mode. The dual and auto range modes have two
SO
span factors (high and low). This allows each range to be calibrated
2
separately. This is necessary if the two ranges used are not close to one
another. For example, a low SO
10 ppm. For more information about range modes, see
Selection" on page 3-66.
Home Screen>Calibration (single range mode)
Home Screen>Calibration (dual or auto range mode)
The Calibration screen contains the following information:
Calibrate Background: Sets the SO
G
Calibrate Span Coefficient: Sets the span coefficient when in single
G
range mode.
range of .5 ppm and a high SO
2
reading to zero.
2
43iQ Instruction Manual
Operation
Calibration
range of
2
"Range Mode
3-9
Advertisement
Chapters
