Channel Delays - Datasat AP25 Installation And Operating Manual

4.3.8.5 Channel Delays

Menu (System) > Formats > Channel Profile > Channel Delays
Figure 72. Channel Delays
Delays can be set for each of the 16 channels. Touch the Delays box under the desired channel.
Enter the delay by dialing in the correct value using the front panel adjustment knob. Touch the
right selection tabs to switch between input/output channels 1-8 or 9-16, and notice that the
individual channel numbers will change per your selection in the channel boxes.
Input Delays may be set in 1 millisecond increments (000-999ms). The input delay is applied
to the channel before the crossover/routing point.
Output Delays may be set in 0.1 millisecond increments (000-120ms). The output delay is
applied to the channel after the crossover/routing point.
The Total delay (Input + Output) for each channel is shown at the bottom of the screen.
Surround delays (channels 5, 6, 7 & 8) should normally be set as a format option for each
individual format.
AP25 Installation & Operating Guide
AP25 Installation and Operating Guide
Document # 9301H79500 Ver. 1.00
Page 92