Uc Open Xp Io Specifications - Carrier UC Open XP Installation And Startup Manual

UC Open XP IO specifications

Power
Binary inputs
Universal inputs
Input resolution
Input pulse frequency
Binary outputs
Protection
Status indicators
Environmental operating
range
Storage temperature range
Physical
UC Open XP/UC Open XP IO
24 Vac ±10%, 50–60 Hz
13 VA power consumption
26 Vdc (25 V min, 30 V max)
Single Class 2 source only, 100 VA or less
IN 1 - 8 are binary only and support pulse counting up to 10 Hertz,
dry contact only.
IN 9 - 16 are universal inputs, jumper selectable between
thermistor/dry contact and 0-5 Vdc.
10 bit A/D
10 pulses per second max. Minimum pulse width (on or off time)
required for each pulse is 50 msec.
8 binary outputs, configured as dry contact, normally open, and
must be powered from a Class 2 power source.
Incoming power and network connections are protected by non-
replaceable internal solid-state polyswitches that reset themselves
when the condition that causes a fault returns to normal. The
power, network, input, and output connections are also protected
against voltage transient and surge events.
LED's indicate status of communications, running, errors, and
outputs
0 to 140° F (-18 to 60°C), 0 to 90% relative humidity, non-
condensing
-24 to 140°F (-30 to 60°C), 0 to 90% relative humidity, non-
condensing
Rugged aluminum housing with removable screw terminals
5