Mpc Open Xp Specifications - Carrier MPC Open XP Series Installation And Startup Manual

Table of Contents

Advertisement

MPC Open XP specifications

Driver
Maximum number of control
programs*
Maximum number of
BACnet objects*
Maximum number of third-
party integration points
using Snap*†
* Depends on available memory
† BACnet third-party integration points are not counted.
Power
BACnet port
Rnet port
Local Access port
Xnet Remote Expansion port For communication with expanders MPC Open XPIO48 and/or MPC Open
Inputs
Input resolution
Input pulse frequency
Outputs
Output resolution
Memory
Real-time clock
MPC Open XP
MPC Open XPIO48/816
Installation and Start-up Guide
drv_mpcxpopen_vanilla
999
12000
200
24 Vac ±10%, 50–60 Hz
50 VA power consumption
26 Vdc (25 V min, 30 V max), 23 W
Single Class 2 source only, 100 VA or less
For communication with the controller network using BACnet ARC156 (156
kbps) or BACnet MS/TP (9600 bps – 76.8 kbps)
Supports up to 15 wireless and/or ZS sensors, and one Equipment Touch or
TruVu™ ET Display
Supplies 12 Vdc/210 mA power to the Rnet at an ambient temperature of
77°F (25°C) with a 24 Vac nominal power source.
NOTE Ambient temperature and power source fluctuations may reduce the
power supplied by the Rnet port.
NOTE If the total power required by the sensors on the Rnet exceeds the power
supplied by the Rnet port, use an external power source. The Wireless Adapter,
Equipment Touch, or TruVu™ ET Display must be powered by an external power
source. See the specifications in each device's Installation and Start-up Guide to
determine the power required.
For system start-up and troubleshooting using Field Assistant
XPIO816. Up to 3 expanders with a maximum of 92 points between the MPC
Open XP and the expanders.
12 inputs, configurable for 0–5 Vdc, 0–10 Vdc, 0–20 mA, RTD, thermistor, or dry
contact
14 bit A/D
40 pulses per second. Minimum pulse width (on or off time) required for each
pulse is 12.5 msec.
8 outputs for 24 Vdc relay driver, 0–10 Vdc, or 0-20 mA. Does not support dry
contact output channels.
12 bit D/A
16 MB non-volatile battery-backed RAM (with 12 MB available for use), 8 MB
Flash memory, 32-bit memory bus
Battery-backed real-time clock keeps track of time in event of power failure
3
Introduction
CARRIER CORPORATION ©2019
All rights reserved

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mpc open xpio48Mpc open xpio816

Table of Contents