Carrier UC Open XP Installation And Startup Manual page 20

UC Open XP installation
Set the appropriate jumpers on the UC Open XP.
3
To use...
Any input
Aux Power
Out port
Connect the binary output wiring to the screw terminals on the UC Open XP and to the controlled device.
4
16
For...
Thermistor Set each input's
Dry contract Universal Input Mode
0–5 Vdc Select jumper to the
0-10 Vdc type of signal the input
0–20 mA will receive.
RTD
Internally- Set the Select jumper to +5V or +24V as
powered required by the sensor.
4-20 mA
UC Open XP/UC Open XP IO