Toyota SIENNA 2022 Manual page 487

21Turn the compressor switch
on to inflate the tire until the
recommended tire inflation
pressure is reached. Drive for
about 3 miles (5 km) and
then perform step 19.
22Attach the air release cap to
the end of the hose.
If the air release cap is not
attached, the sealant may leak and
the vehicle may get dirty.
23Store the bottle in the lug-
gage compartment while it is
connected to the compres-
sor.
24Taking precautions to avoid
sudden braking, sudden
acceleration and sharp turns,
drive carefully at under 50
mph (80 km/h) to your Toyota
dealer that is less than 62
miles (100 km) away for tire
repair or replacement.
Make sure to tell your Toyota
dealer when you have them repair
or replace the tire that sealant is
injected.
■ If the tire is inflated to more
than the specified air pressure
1
Disconnect the hose from the
valve.
7-2. Steps to take in an emergency
2
Install the air release cap to the
end of the hose and push the
protrusion on the air release cap
into the tire valve to let some air
out.
3
Disconnect the hose from the
valve, remove the air release cap
from the hose and then recon-
nect the hose.
4
Turn the compressor switch on
and wait for several seconds,
and then turn it off. Check that
the air pressure indicator shows
the specified air pressure.
If the air pressure is lower than the
designated pressure, turn the com-
pressor switch on again and repeat
the inflation procedure until the
specified air pressure is reached.
■ After a tire is repaired with the
emergency tire puncture repair
kit
● The tire pressure warning valve
and transmitter should be
replaced.
● Even if the tire inflation pressure is
at the recommended level, the tire
pressure warning light may come
on/flash.
WARNING
■ When fixing the flat tire
● Stop your vehicle in a safe and
flat area.
487
7