180
3-3. Adjusting the seats
The shift lever has been
shifted to P.
The power switch has been
turned off.
The driver' seat belt has been
unfastened.
When any of the following has
been performed, the driver' seat
and steering wheel automati-
cally return to their original posi-
tions.
The power switch has been
turned to ACC or ON.
The driver' seat belt has been
fastened.
Recording/recalling a
driving position
Recording procedure
■
1
Check that the shift lever is in
P.
2
Turn the power switch to ON.
3
Adjust the driver's seat,
steering wheel, outside rear
view mirrors and head-up
display (if equipped) to the
desired positions.
4
While pressing the "SET" but-
ton, press button "1" or "2"
until the buzzer sounds.
If the selected button has already
been preset, the previously
recorded position will be overwrit-
ten.
Recall procedure
■
1
Check that the shift lever is in
P.
2
Turn the power switch to ON.
3
Press one of the buttons for
the driving position you want
to recall until the buzzer
sounds.
■
To stop the position recall oper-
ation part-way through
Perform any of the following:
Press the "SET" button.
●
●
Press button "1" or "2".
●
Operate any of the seat adjust-
ment switches (only cancels seat
position recall).
●
Operate the tilt and telescopic
steering control switch (only can-
cels steering wheel position
recall).